It’s happened to every single one of us.
We leave our weed pipes in our lap and stand up, or we bump the table our bong is sitting on, both of which result in quickly ruining our day.
Some glass shatters into a million irreparable pieces, while other pipes may chip or even have a clean break across.
These less dramatic breaks can be easily repairable, sometimes they can even be made to look good as new.
So how do you fix a broken bong or a broken glass pipe?
The Quickest Fix:
Buy a new one!
These are a few of are favorite online headshops here at THCoverdose.
But, if you’re sure you’d rather fix it, keep reading.
Thrive Leads Shortcode could not be rendered, please check it in Thrive Leads Section!
Quick Ways to Fix a Broken Bong
Let’s face it: Most best bongs nowadays are going to set you back a pretty penny.
So when you break one, it’s especially devastating. Here is a couple of quick ways to fix a broken bong.
Bong Repair with Food Grade Silicone
Depending on where the break is you can use food grade silicone.
This method works on areas like your joints or the tube of your bong.
Food grade silicone works best when repairing cracks or notches in the glass; it’s not going to help you if you have a completely broken bong that you need to piece back together.
Bong Repair Using Epoxy
Two component epoxy is a great long lasting way to fix your broken glass bong.
When buying epoxy, though, you need to make sure that you buy an epoxy with no solvents like a food grade epoxy.
Epoxy works best on fixing bongs with clean breaks, and the joints of the bong accessories found here.
If your bong has a real jagged break, you might consider buying a glass cutter to create a clean break, and then sand it down slightly before you applying epoxy to bond the two pieces of glass together.
If your break is at the base where bong water will be, after time the epoxy will get bogged down by water and start to leak.
You can help prevent this, by keeping your bong empty in between uses.
Fixing a Bong with Duct Tape
Now, this method is if you’re are in a hurry, low on funds, or if you just want to get janky with it.
Duct tape works well when fixing small cracks or cheap glass bongs.
If your break is at the base where the water stays, then this fix will only work very temporarily at best.
Fixing Your Bong with a Bucket
What? That’s right, a bucket.
You can also use a sink, Tupperware bowl, or a bathtub. Pretty much anything that holds water.
This fix, well it’s more of a workaround, is for when you break the base of your bong.
What you do is sit the bong in the water and voila, that’s it.
The water in the bucket (or whatever you end up using) acts as the base of the bong and creates an airtight seal.
Best Ways to Fix a Broken Pipe
More often than not, a when a glass pipe breaks, it’s beyond repair.
Most glass bongs break from being knocked over and fall a relatively short distance, a glass pipe, however, is usually the victim of a pretty severe fall.
If your pipe is shattered, I would probably just move on.
If the tube is broken clean off, you have a crack, or if a notch of glass is broken out, try one of these methods to repair your glass pipe.
Quick Steel or JB Weld
Quick Steel or JB Weld are both great options that do relatively the same thing.
They are a putty-like material that can be used to fill holes or bond glass back together.
If the crack or break is anywhere near the bowl of your pipe, you should avoid using this method.
Fix the Pipe with Epoxy
Epoxy is another quick and easy method. It can quickly bond the pieces of your glass pipe back together.
However, avoid using it anywhere near the bowl of the pipe.
Duct Tape
Again, a duct tape fix should probably be reserved fora last minute quick fix.
The process, however, is pretty self-explanatory. If your glass pipe has a clean break across the tube, then connect the two pieces and tape away.
Blow Torch
Let me start off by saying this is best left to the professionals in a professional setting, with all proper personal protective equipment.
If you have access to the proper equipment, fixing a clean break on a glass pipe can be achieved with a fairly simple process.
Watch the video below to learn how to fix a broken glass pipe like a professional.
Usually, the price of a hand pipe is not going to justify hiring a professional to repair your pipe.
However, some real heady pieces can creep up there to a price range that will make hiring a pro make sense, and, of course, there is always the sentimental value that might make you feel inclined to hire a pro.
The process is simple:
Call around to your local headshops or local glass blowers, and you will be able to get some good quotes.
Keep in mind that the piece will need to be 100% clean before you can take it in anywhere to get it looked at.
Broken Beyond Repair
Sometimes you just have to face the music, and accept that your glass is gone.
That’s when you should turn to either a local headshop or an online head shop.
So while not all pipes and bongs can be fixed, most can be fixed with a little bit of know-how and creativity.
What method works best for you?
Is there any method you use that I didn’t mention here?
Let me know in the comments section!
Bruh, I literally had my bong for about two days and my mouth piece broke off. Big oof! Hopefully this works, thanks for the article!